Installation process of contactor accessories

Today we will introduce the installation of contactor accessories.

First install the auxiliary contact block. When installing, make sure that the top mount is consistent with the contactor logo. Place the top mount vertically above the contactor and push it smoothly along the notch until it snaps into place.

Next install the pneumatic delay module. There is a buckle on the delay module. Align the buckle position with the left groove on the base. After alignment, press down and hear a "bang".

Next install the side mount. When installing, make sure the logo is facing up. Align the support buckle of the side-mounted auxiliary contact with the contactor groove. After aligning the buckle, press the side hook into the groove. Hear a "bang", indicating that the side mount is installed in place.

Finally, install the relay. First, loosen the screws at the bottom of the contactor and align the buckle at the thermal relay position with the groove on the base. After inserting it into the groove, lock it in place with a screwdriver. Then tighten the screws and the thermal relay is installed.